Vivotek Network Camera FD7141(V) Manual de usuario descargar pdf (Pagina 8)

EN - 7

English

General Connection (without PoE)

N.C.

AC24V

ITI

Network Deployment

1. If you have external devices such as sensors and alarms, make the

connection from the general I/O terminal block.

2. Use the supplied RJ45 female/female coupler

to connect the Network Camera to a switch.

Use a Category 5 Cross Cable when Network

Camera is directly connected to PC.

3. Connect the power cable from the Network

Camera to a power outlet.

N.C.

AC24V

N.C.: No Connector

AC24V: Power in AC 24V

GND: Ground

D I : Digital Input

D O : Digital Output

+12V : Power, 12V DC

GND

+12V

Ceiling mount without the bottom base (Embedded)

1. Attach the supplied ceiling hole template sticker to the ceiling.

2. Open a hole along the inner circle of the sticker.

3. Using the 3 circles on the sticker, drill 3 pilot holes into the ceiling. Then hammer the three supplied

plastic anchors into the holes.

4. Mount the Network Camera to the ceiling and feed the cables through.

5. Using the three holes on the side of the camera base, insert the three supplied screws into the cor-

responding holes and secure them with a screwdriver.

Ceiling Hole Template Sticker

Drill hole

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Sin comentarios

Vivotek Network Camera FD7141(V) Manual de usuario Pagina 8