Vivotek Network Camera FD7141(V) Manual de usuario descargar pdf (Pagina 6)

EN - 5

English

First, use a screwdriver to loose the three screws and detach the dome cover from the

camera base. Then, follow the steps below to install the camera to either a ceiling or a wall.

Hardware Installation

Ceiling mount with the bottom base

1. Attach the supplied alignment sticker to the ceiling.

2. Using the 10 circles on the sticker, drill 2 pilot holes symmetrically on each side into the ceiling. Then

hammer the four supplied plastic anchors into the holes.

3. Through the four holes on the bottom base, insert the four supplied screws into the corresponding

holes and secure the bottom base with a screwdriver.

4. Feed the cables through hole A or B. If you want to use hole B, remove the rubber stopper with a

screwdriver.

5. Secure the camera base to the bottom base with three supplied screws.

N.C.

AC24V

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Sin comentarios

Vivotek Network Camera FD7141(V) Manual de usuario Pagina 6