Vivotek IP7330 Especificaciones descargar pdf (Pagina 6)

VIVOTEK

6 - User's Manual

Installation

Hardware Installation

1. Loose the liquid tight connectors, and then remove the rubber.

2� Loose the back cover�

3� Tear down the aluminum foil vacuum bag and take out the silica gel� Attach the supplied silica

gel to the inner side of the Network Camera� (Please replace the silica gel with a new one if

you open the back cover after installation�)

4� Make sure all cable lines are securely connected�

5. Tighten the back cover, rubber and liquid tight connectors.

6� Secure the Network Camera to the wall/ceiling by the supplied camera stand�

Note

If you want to use your own cable lines, please loose two supplied screws and take out the

power board� Then be careful to make connections as the illustration below�

Silica gel

Ceiling mount

Wall mount

Upper Side

Bottom Side

Power Cord

Terminal Block (from left to right)

1: AV24V (red)

2: AC24V (red)

3: DI (white)

4: GND (black)

Ethernet Cable

Screws

1 2 3 4 5 6 7 8 9 10 11 ... 113 114

Sin comentarios

Vivotek IP7330 Especificaciones Pagina 6