Vivotek FD7131 Especificaciones descargar pdf (Pagina 7)

VIVOTEK - A Leading Provider of Multimedia Communication Solutions

User's Manual - 7

3� Feed power to the Network Camera and connect it to the Internet� For more information,

please refer to Network deployment on page 9 for details�

4. Install the “Installation Wizard 2“ to assign IP address to the Network Camera. For more

information, please refer to Software installation on page 12 for details�

5� Access to the Network Camera from the Internet� For more information, please refer to

Accessing the Network Camera on page 13 for details�

6� Based on the live image retrieved from the camera, adjust the camera lens as following steps�

To adjust the viewing angle

■ Loosen the pan screw, then turn the lens module left and right� Upon completion,

tighten the pan screw�

■ Loosen the tilt screws on both side of the camera, then turn the lens module up and

down� Upon completion, tighten the tilt screws�

■ Loosen the image adjustment screw, then turn the lens to adjust the image orientation�

Upon completion, tighten the image adjustment screw�

Alignment sticker

When mounting to a ceiling

Through the two holes on each side of the camera base,

insert the supplied two screws to corresponding holes and

secure them with a screwdriver�

When mounting to a wall

■ Attach the alignment sticker to the wall�

■ Through the two circles on the sticker, drill two pilot holes into the wall�

■ Hammer the supplied plastic anchors into the holes�

■ Align the two holes on each side of the camera base with the two

plastic anchors on the wall, insert the supplied screws to corresponding

holes and secure them with a screwdriver�

Rotate the screw

Turn the lens

Audio Out Mic. In Ext. Int.

1 2 3 4

Audio Out Mic. In Ext. Int.

1 2 3 4

Audio Out Mic. In Ext. Int.

1 2 3 4

Loosen

Tighten

Loosen

Tighten

Loosen

Tighten

1 2 3 4 5 6 7 8 9 10 11 12 ... 121 122

Sin comentarios

Vivotek FD7131 Especificaciones Pagina 7